Skip to main content

Device

Device information can be found at Computer software -> Device or Hotel App -> Device.

Card#

The card can be used on locks, lift controllers, and energy savers. There are 16 sectors on Mifare card. TTHotel software use the first 10 sectors by default. The rest sectors can be used for other system. If you want to change the selection of sectors, please send email to us.

Disable Lost Card#

If a card lost, you can disable it in two ways:One way:

  • Mark the card as a lost card at computer softwarea at Access - > Card
  • Disable this card on Staff App near the lockBTW, the card marked as lost will also be disabled when issue a new card and unlock with it.

The other way:

  • Issue a new card writing lost card information into it.
  • Put this card on the lock will disable the lost card from this lock.

Card Encoder#

The card encoder is used to issue card. It writes the access into the card. Only card encoder from Sciener or TTLock works with TTHotel system, like E3.

Smart Lock#

Only smart locks with solution from Sciener or TTLock work with TTHotel.

Locks can be configured with Staff App via bluetooth.

To reset a lock, you may be asked to enter initial code, it is 000#.

Lift Controller#

Only lift controllers from Sciener or TTLock work with TTHotel. The lift controller can be configured to work in one of the three modes:

  • Floor(s) with door access
  • All floors

Power Saver#

The power saver can be configured to work in one of the three modes:

  • Work with any card
  • Work with current hotel card
  • Work with current room card

Gateway#

Only lift gateways from Sciener or TTLock work with TTHotel. Gateway connects locks to network. You can control the lock remotely with it.